SenSafe® Iron (Fe+2) (Pocket-Pack)
Check your Ferrous Iron (+2) with Confidence using our SenSafe® Iron Check. Featuring our patented Aperture Technology, make sure your Iron levels are where you want them to be. Contains 30 individually wrapped tests in our new environmentally friendly Pocket-Pack!
- Safe and non Hazardous
- Low detection levels
- Industry accepted TPTZ method.
Patented technology allows for a detection sensitivity of 0.1 ppm (mg/L) on the Iron Check test strip. This test promises to be an attractive alternative to wet chemical iron tests for several reasons: There are no hazardous chemicals to mix (an MSDS is not required); Quick results are obtained in minutes; And, best of all, the Iron Test Strips are safe and easy to use for fast accurate results within the ranges of 0.1 to 5 ppm (mg/L), which permits the measurement of typical iron levels found in well, tap, and stream water. The test is very convenient to run: dip test strip into sample for 30 seconds with constant back and forth motion, remove, and match color after 2 minutes to quantify the Iron level in the sample.
For best Accuracy use with a fresh drawn sample before Ferrous Iron +2 (if present) oxidizes to Ferric Iron +3 in contact with oxygen in air.
Range 0, 0.02, 0.05, 0.1, 0.2, 0.3, 0.5, 0.75, 1.0, 2.0, 5.0 ppm
Made in USA